ПРОМЫШЛЕННЫЙ ИНКУБАТОР СТИМУЛ ИП-16 М1

Incubator Stimul-16 M1
Incubator capacity
16 128 chicken eggs
39,680 quail eggs
9 360 duck eggs
6 240 goose eggs
10,400 Turkey eggs
It works on a single-stage loading system, but it is possible to use the method of loading batches of eggs. Incubators can be assembled in blocks from any number of chambers. The incubator has 4 incubation carts with tray rotation function.

The size of the incubator

Width-2151 mm
Depth-2553 mm
Height-2200 mm

Electricity consumption

Total installed capacity, kW-no more than 4.6:
Fan motor-1.5 (1 PC);
Rotation mechanism actuator-0.05 (2 PCs);
Ten -1 kW. (3 pieces)
Power supply network: 3N~50 HZ, 380 V.
Body
The incubator body is made of 45 mm thick sandwich panels. The thermal insulation material of the panels is extruded polystyrene. The outer layers are PVC plastic. The body frame is made of high-quality stainless steel.


The control unit of the camera – CBO-01.P.In.24
The unit compares information about the current temperature and humidity values with the set values, calculates their absolute deviations, and issues appropriate commands for controlling the heater, cooler, and humidifier.

Air exchange system
Designed to provide the necessary air exchange inside the chamber and additional air cooling when the air temperature reaches + 38.3 ° C. The system is located on the back and top panels of the cameras, consists of dampers and rods, and a fan.

Heating system
The incubator has 3 tubular electric heaters, which are located on the back wall of the incubator, heating Elements made of stainless steel.

Cooling system
It includes a two-circuit radiator on the back wall, which is regulated by a solenoid cooling valve.

Dampening system
Turns on the water supply system from the valve to the humidification Cup in the center of the fan. The solenoid valve is controlled by the control Unit of the chamber BUK-01. P.V. 24, providing automatic water supply to the Cup fixed on the crosspiece of the fan, from where it spreads over the blades and, evaporating, provides the necessary humidity.

Rotate trays
The tray rotation system is based on the rotation mechanism on the back wall of the incubator and sunset carts with the function of turning the trays 45 degrees in both directions with the ability to adjust. This technology allows you to limit yourself to one bookmark at the stage of acceptance of the incubation egg without subsequent transfers until the transfer of eggs to the hatching Cabinet. The Executive element of tray rotation is an actuator.